DHI Hair Transplant

Lots of new solutions have been found for hair loss and baldness with the developing technology in the recent years. The graft placement method performed by Doctor Young Dhoi and which has been applied for years in the Far East Asia is called DHI hair transplant. Almost all of the processes with this method have resulted in success. In order for this operation to be performed, the suitability of the skin must be determined with the necessary tests. The approval of the specialist for this method is necessary for successful results
 How is DHI Hair Transplant Done?
DHI hair transplant is performed with a spring system resembling a ballpoint pen. This small device, shaped like an interlocking ballpoint pen, has an outer teflon coating and is designed resistant to 130 degrees celcius. There are needle points where grafts are placed at the end. This needle resembles an injector but it is vertical and the end points are ripped. The ripped ends are made this way so that the hair grafts can be placed into the needle before the transplant.4 to 6 implanter pens are used for an average DHI hair transplant process. The method consists of two stages.Placing the hair follicles into the pen: A specialist and 2 assistants take part in this stage. It is important that this step is completed quickly. Hair follicles taken from the petri dish are placed inside the pen one by one. These hair follicles are placed into the needle by sliding.Transplant of the grafts placed inside the needle: The needle points with the grafts inside are approached to the hairless area with an appropriate angle and the skin is pierced with the needle. At this point, the pen is pressed from the top. After the hair follicle at the needle’s end is pushed into the hole in the hairless area, DHI hair transplant is done.
Important Matters in DHI Hair Transplant As it is in every application, it is important that DHI hair transplant is carried out by a specialist. The size of the holes pierced in the skin is of particular importance during the process. There is no possibility of success if the holes are too big.
Send Message